Profile

• 16 Sizes  (32 ... 180)
• Nominal power PN2 0,082 ÷ 117 kW
• Nominal torque MN2 ≤ 1 000 daN m
• Transmission ratio iN 6,3 ... 6 300
  
• Universal mounting design
• Strong patented casing
• Wide size range
• IEC standard motor
• Pinion of final stage with three bearings

• Power   P1  0,5 ... 100 kW
• Variation ratio   R 100
• A.c./d.c. digital converter, with self-adjusting feature on motor's characteristics and programmable with remote keypad D.c. motor with stator square pack
• IP 23 or IP 44 protection
• Two thermal overload relays

• Planetary gearmotors (EP10 series)
• Motor standardized to IEC directly keyed into the high speed hollow shaft
• Gearmotor properly dimensioned in each part in order to be equipped with very large motors, to transmit high and maximum nominal torque values, to withstand high loads on low speed shaft end
  

Rossi extends its HyCLEAN gearmotor range with the introduction of
EasyCLEAN design, becoming the new reference point on the market for the use in particularly corrosive and aseptic environments. The new self-draining design of the stainless steel housing has been conceived to avoid any recess, sharp edges and steps difficult to be cleaned. 

• 7 Sizes 
• Nominal power PN2 0,6 ÷ 85 kW
• Nominal torque MN2 ≤ 1 180 daN m
• Transmission ratio iN 10 ... 25
• Especially designed for belt conveyor drives 
• Easy shaft-mounting design 
• Strong casing

• Certified resistance to sanifications applying the usual cleansing agents
• Highly abrasion and scratch-proof
• Resistance to high pressure water jets
• Easy flowing surface
• Uniform thickness
• Approved by NSF

• Sizes (100 ... 451)
  
• 2I, 3I, CI, C2I trains of gears
  
• Universal mounting having feet integral with housing on 4 faces
• Standard solid low speed shaft made of steel with customizable screw shank hole
• Gear reducers: input face with machined with fixing holes; high speed shaft end with key
  

• Parallel & right angle shaft gear reducers (MN2 90 ... 400 kN m)
• 10 Sizes (400 ... 631)
• Nominal power PN2 16 ÷ 3 650 kW
• Nominal torque MN2 90 ... 400 kN m
• Transmission ratio iN 8 ... 315

• Universal mounting design
• Rigid and precise monolithic casing in cast iron
• Cylindrical worm shaft with ground and superfinished involute profile (ZI)
• Load capacity and efficiency to BS 721-83 integrated with ISO/CD 14521
• Forced ventilation
• IEC standard motor

• Interchangeability (hollow low speed shaft diameter)
• Motors to IEC standards
• Universal mounting with lower feet, integral with casing and B14 flange on 2 faces
• Rigid and precise cast iron monolithic casing with motor mounting integral flange
• Improved and up-graded modular construction both for components and assembled products
• High, reliable and tested performances (Ni bronze)
• Reduced maintenance

 

• Second-generation, high temperature, spike-resistant magnet wire for extended motor life. 
• Grease bearing nozzle for easy lubrication and service. 
  
• A oil seal on the shaft protects the drive-end bearing from dirt and moisture. The inner bearing cover has a felt seal.